Draco Motor Mount
Coming soon…
The Draco Motor mount and integrated centre diff mount is made of Aluminum 7075-T6 and then hard anodized. It is designed to allow easy access to the centre diff and also allows larger motors up to 42mm in diameter to be used. The Centre Diff mounts are a two-piece design and can be split by removing 4 screws. This enables the user to remove the centre diff very easily and very quickly during maintenance without removing the entire mount from the vehicle.
The Motor mount itself has been modified to open up more options for Pinion gears. Using the stock 50T/48T spur gears you can now use pinions from 13T to 22T for those bashers who enjoy making speed runs.
Features:
Made from 7075-T6 Aluminum
Hard Anodized Clear for durability and wear resistance
Two-Piece design for easy and quick centre diff access
Optional Draco Centre Tower Braces compatible (Truggy Flux Only)
Compatible with up to 42mm diameter 1/8th scale motors
Sliding motor plate for proportional gear mesh set up
Capable of using 13T-22T Pinions with a 48T or 50T Spur gear
Included Motor Pad for adding support at the rear of the motor during jumps and bashing
Vehicle Compatibility:
-HPI Vorza Flux Buggy
-HPI Vorza Flux Truggy
-HPI Vorza S Flux Buggy
-HPI Vorza S Flux Truggy
-HPI Vorza Flux HP (2009)
Motor Compatibility:
-All 4275 Motors for 1/8th scale vehicles and below (Motor mount is limited to 42mm diameter motors only so any 1/6th scale motors including the 4985 motors from Hobbywing are not compatible)
Overview:
-
Draco Motor Plate
DRA-412 Draco Motor Plate
This is a Hard Anodised 7075-T6 Aluminum motor plate with mounting locations for M4 and M3 screws. The motor mount slides, allowing you to gear up for those speed runs or gear down when additional torque is required. 13T to 22T pinions are compatible. The mount was designed to open up motor options like Castle 15 Series and Hobbywing 4275 motors.
Please note: Motors over 42mm in diameter are not compatible.
-
Draco Rear Upper and Lower Plates
DRA-411 Draco Rear Lower Plate and DRA-413 Draco Rear Upper Plate
Also made of 7075-T6 Hard Anodised aluminum, these plates are 8mm thick and are split so the centre diff can be easily removed for maintenance. The mount has been rotated 8 degrees to clear the side guards of the Truggy and allow the motor and motor mount to slide out easily. The upper plate has been threaded for the centre diff top plate to be fixed which keeps the rear upper plate, front upper plate and centre diff top plate to be removed as one.
-
Draco Front Lower and Upper Plates
DRA-414 Front Lower Plate and DRA-415 Front Upper Plate
Like the rear diff plates the front are also split for easy-access to the centre diff. With a smaller width of 7mm the front plates are smaller in order to clear the components mounted to the chassis.
-
Draco Centre Top Plate
DRA-416 Centre Top Plate
With a centre diff top plate made of 5mm 7075-T6 hard anodized aluminum adding rigidity to the centre diff and motor mounts, you can breathe easy. Extra material has been added where the centre tower braces attach to dramatically reduce chassis flex (available for the Truggy Flux only)
